The Deviation Type section of the Cm4d.ini file allows you to customize the default Deviation Type settings.
For all of the following parameters with a value of either 1 or 0:
Disable =0
Enable =1
For all of the following parameters with a value other than 1 or 0, see the "Alternative Value(s)" Column.
"Allow" values are read every time CM4D is opened (run-time)
"AllowTypeSet" values are read every time CM4D is opened (run-time)
"Type" values are only used for new documents.
|
Parameter= |
Default Value |
Alternate Value |
Notes |
|
AllowTypeSet__Chr__= |
1 |
0 |
The AllowTypeSet parameters control whether a user is given access permissions to modify the deviation types. Locked values appear in parenthesis: (vec) |
|
AllowDevTypeVector= |
1 |
0 |
The AllowDevType parameters allow you to define which Deviation Types will be available in the Query level Deviation Types dialog for selection. Any combination of Deviation Types may be used, but at least one of the AllowDevTypes must be set to 1, or AllowDevTypeVec and AllowDevTypeCar will be automatically enabled (set to 1) for the current session of CM4D. The AllowDevType settings will override the default type set in the Type parameters.
|
|
AllowDevTypeCar= |
1 |
0 |
|
|
AllowDevTypeOffset= |
0 |
1 |
|
|
SetDevTypeFromDefaultSift= |
0 |
1 |
This setting is used ONLY for migration of any documents created prior v10.910 to be accessed with v10.920 or later. |
|
#Default Settings if SetDevTypeFromDefaultSift=0 |
|||
|
Type__Chr__= |
"vec" |
"car" "off" |
The Type parameters determine the default deviation type. When the AllowTypeSet is disabled (i.e. set to 0), or locked, this value will determine what the locked deviation type will be. |