Notice
Once an annotation Chain is converted
into a ReportTweak report, it cannot
be reverted back to a Chain.
Existing annotation Chains may be converted into ReportTweak reports.
Notice
Once an annotation Chain is converted
into a ReportTweak report, it cannot
be reverted back to a Chain.
For this example, an existing AutoReport will be used to demonstrate how ReportTweak reports can be created.
1. Select a chained annotation from the existing Chain.
2. If you want to check if an annot is part of a chain, go to the Annot Properties dialog and check the Chain Info section of the General tab.
3. Toggle ReportTweak mode.
4. Click Activate to create a ReportTweak Report.
5. In the dialog that pops up, click OK to convert the Chain into a ReportTweak report.
6. Your annot Chain is now a ReportTweak report, as indicated by the green highlight around each annot that is included in the ReportTweak.
7. Refer to the section about the Uncross menu option in the topic ReportTweak.
