~miniball,isvalid~
Returns 1 or 0, indicating whether or not the Miniball is valid. The variable ~miniball,valid~ may also be used to return the same result.
~miniball,msk#~
Returns the number of masked data points.
~miniball,m-dia~
Returns the diameter of the Miniball.
~miniball,m-out#~
Returns number of points that are Out of Miniball Limit.
~miniball,m-out%~
Returns the percentage of out of limit points for Miniball {m-out#/pnt#}.
~miniball,m-rad~
Returns the radius of the Miniball.
~miniball,m-tol~
Returns the tolerance of the Miniball.
~miniball,m-told~
Returns the diametrical tolerance of the Miniball.
~miniball,pnt#~
Returns the number of points included in the Miniball calculation.
~miniball,ref~
Returns the Reference Feature used in the Constructed Feature.
~miniball,refdesc~
Returns the Description (if available) of the Reference Feature.
~miniball,refpol~
Returns the Polar value of the Reference Feature used in the Constructed Feature.
~miniball,refx~
Returns the Nominal X value of the Reference Feature.
~miniball,refy~
Returns the Nominal Y value of the Reference Feature.
~miniball,refz~
Returns the Nominal Z value of the Reference Feature.
~miniball,ref#~
Returns the number of features referenced by the constructed Polar feature.
~miniball,status~
Returns one of the five states of the Miniball calculation for a single feature.
· Masked - the feature is masked
· Conform - the feature is within the Miniball tolerance
· Zero! - the feature is out of Miniball tolerance
· Mini! - this status does not yet apply
· Both! - this status does not yet apply
~miniball,x~
Returns the horizontal offset of the Miniball. The variable ~miniball,x-off~ may also be used to return the same result.
~miniball,y~
Returns the vertical offset of the Miniball. The variable ~miniball,y-off~ may also be used to return the same result.
~miniball,z-dia~
Returns the diameter of the Zeroball.
~miniball,z-out#~
Returns the number of points that are Out of Zeroball Limit.
~miniball,z-out%~
Returns the percentage of out of limit points for Zeroball {z-out#/pnt#}.
~miniball,z-rad~
Returns the radius of the Zeroball, from center zero.
~miniball,z-tol~
Returns the tolerance of the Zeroball.
~miniball,z-told~
Returns the diametrical tolerance of the Zeroball.