Alignment Tutorial - Simple Block
Click here to see this page in full context
  1. Home >>
  2. CM4D >>
  3. CM4D >>
  4. Alignment >>
  5. Alignment Tutorial >>
  6. Alignment Tutorial - Simple Block

Alignment Tutorial - Simple Block

Topic ContentsTopic Contents
  1. Files Required
  2. Alignment Definition
  3. Sample Data

The Simple Block Tutorial demonstrates an alignment with full setup. It is executed in four phases:

Phase 1: Put Data in Database

Phase 2: Create Subroutine and Alignment

Phase 3: Create Document

Phase 4: Use Alignment

Each phase is described here for completeness, but Phase 1-3 may be provided for you.

Files Required

Download Data Files

Alignment Definition

A Datum – Z axis defined by 3 surface points – P01, P02, P03

B Datum – Y axis defined by 2 surface points – P05, P06

C Datum – X axis defined by 1 surface point – P09

Sample Data

The Sample data provided has been engineered to demonstrate the effect of alignment.

Sample 1 (Simple Block 1) has the four Z points on the top surface of the block (P01-P04) moved in Z by varying amounts.

Sample 2 (Simple Block 2) has the four Y points on the side surfaces of the block (P05-P08) moved in Y by varying amounts.

Sample 3 (Simple Block 3) has the four X points on the end surfaces of the block (P09-P12) moved in X by varying amounts.

Sample 4 (Simple Block 4) is a combination of Sample 2 and Sample 3.

All Samples have the Hole (P13) and Slot (P14) moved.

 

 

Can we improve this topic?