The operator carrying out the audit will have a list of rules that may relate to the defects.
For example, if a jet engine has a cable loom with too few cable ties a rule may state that it should be assigned to a particular re-work centre.
Before a rule is created a category must be created to contain the rules.
Create a Rule Category
Rule Categories allow the operator to filter a list of rules so that only those related to the required area of interest are shown.
Select the Audit tab.
Click Rule Categories/Rules.
A list of the existing rules and rule categories is displayed. Rule categories, and the rules they contain, are shown in the left-hand pane. All available rules are shown in the upper right-hand pane. Audit weights are shown in the lower right-hand pane.
Click the Add button (
) below the left-hand pane.
The Rule Category creation window opens.
Enter a description and a unique code for the rule category.
Click OK.
The rule category is added to the list.
Create Rules and Associate to Category
Select the Audit tab.
Click Categories/Rules.
A list of the existing rules and rule categories is displayed. Rule categories, and the rules they contain, are shown in the left-hand pane. All available rules are shown in the upper right-hand pane. Audit weights are shown in the lower right-hand pane.
Click the Add button () below the upper right-hand pane.
Enter a description and a unique code for the rule.
Select a category for the rule.
Enter comments that will give information about when the rule should be used.
Click OK.
The rule is added to the list and associated to the selected category.